SiliconDust HDHomeRun Instrukcja Naprawy Pobierz pdf (Strona 5)

Tuners not found by DVR software (Windows):

Check 1: HDHomeRun Setup

Run HDHomeRun Setup. Check that two tuners are shown.

● If no tuners are shown - see section on “HDHomeRun not found (HDHomeRun

Software)”.

Check 2: MCE 2005 specific requirements

● MCE 2005 requires an Analog/NTSC TV tuner adapter to be present before it will

allow a digital tuner to be detected. Check that a Analog/NTSC TV tuner is installed

and working.

● Vista, TV Pack 2008, and 7 do not require an analog tuner to be present.

● The “MCE Rollup 2” update is required:

http://www.microsoft.com/downloads/details.aspx?FamilyID=e5daf37e-e243-4410-

bc51-81cf2b56fe6e&displaylang=en

Check 3: Prior SageTV install

The SageTV uninstaller deregisters some BDA components that are required by

other DVR applications.

Run HDHomeRun Setup and click “Reinstall Windows BDA Components” on the

Support tab.

Vista Users:

When prompted for a driver location, use c:\windows\system32\drivers

Digital Cable remapping (Windows):

Symptom: MCE TV Setup Wizard does not find channels above 1800.

1. Run HDHomeRun Setup. Check that the Signal Source is set to Digital Cable. Click Apply.

2. Switch to the Lineup tab and enter the channel editor. Check that channels have remap

numbers. Click Apply.

3. Run through the MCE TV Setup Wizard again. Make sure to choose the Manual option

(channel lineup is not imported by MCE in automatic mode).

Symptom: No channels have remap numbers in the channel editor.

If using an antenna then this is normal - OTA channels are not remapped.

If using digital cable - go to the Tuners tab and set the Signal Source to Digital Cable.

1 2 3 4 5 6 7 8 9 10

Brak uwag

SiliconDust HDHomeRun Instrukcja Naprawy Strona 5